18 November 2013
Last updated at 08:12
Tepco has been preparing for months to remove fuel rods at Fukushima
Workers at Japan’s stricken Fukushima nuclear plant have begun removing fuel rods from a storage pond at the Unit 4 reactor building.
The delicate operation is seen as a necessary step in stabilising the site.
It will take about two days to remove the first 22 fuel rod assemblies, plant operator Tepco says.
Overall, more than 1,500 assemblies must be be removed in what correspondents describe as a risky and dangerous operation set to take a year.
Experts say hydrogen explosions after the earthquake and tsunami in March 2011 have made the current storage facility vulnerable to further tremors.
The fuel rod assemblies are four-metre long tubes containing pellets of uranium fuel, and the fear is that some may have been damaged during the disaster.
When the tsunami struck, water knocked out cooling systems to three of Fukushima’s reactors, which went into a state of partial meltdown.
Unit 4 was undergoing maintenance, so all of its fuel rods were being stored. But a build-up of hydrogen triggered an explosion in Unit 4, damaging its structure.
The removal process, which has been preceded by months of repair work and planning, began on Monday afternoon.
“At 15:18 [06:18 GMT], we started to pull up the first fuel assembly with a crane,” a spokesman for Tepco (Tokyo Electric Power Company) said.
A recently installed crane is being lowered into the pool and hooked on to the assemblies to place them inside a cask.
Removal of fuel rods from the storage pond is a key step in the decommissioning
Tepco has conducted trial runs of the process, which involves large casks
The fuel rods will then be deposited into a more secure storage pool with a cooling system.
Experts say it is vital that the casks are watertight so the rods have no contact with air – which risks overheating and possible contamination.
Yoshihide Suga, Japan’s top government spokesman, said he hoped the operation would go as planned.
“We hope that this [process] will be conducted in a manner that will not disturb local residents, and that the removal will be done on schedule, properly and safely,” he said.
Tepco spokesman Masayuki Ono called the operation “a very important process in moving ahead with the plant’s decommissioning”.
Nuclear Regulation Authority Chairman Shunichi Tanaka has warned that rubble from the blast in the pool could pose a problem, Kyodo news agency reported.
“The fuel has to be handled very carefully. There is a need to make sure that a fuel assembly is not pulled out (from the fuel rack) by force when it gets stuck because of the rubble,” Kyodo news agency quoted him as saying.
The Fukushima nuclear power plant has suffered a number of setbacks in recent months, including a series of toxic water leaks and worker errors.
- 1. Small crane retrieves spent fuel rods from storage pool. A protective shell has been built over the top of the damaged reactor building. There are 1,331 spent fuel rods and 202 unused fuel rods to be removed
- 2. Fuel rods are carefully lowered into specially-constructed casks, which each weigh 91 tonnes and can hold up to 22 rods
- 3. A larger crane lifts full cask out of the storage pond and lowers it out of the building and on to a flat-bed truck. The casks will then be taken to a safe storage pool on the Fukushima site
Are you in Japan? What is your reaction to the removal of fuel rods at the Fukishima nuclear plant? Send us your comments using the form below.